A.R.E. Truck Cap Twist Handle and Lock PA-16827

Description

READ FULL DESCRIPTION!  A.R.E. USES SEVERAL DIFFERENT HANDLES THAT ALL LOOK VERY SIMILAR WITH VERY DIFFERENT FITMENTS.  DO NOT ORDER UNLESS YOU ARE SURE IT IS CORRECT.  WE CAN VERIFY FITMENT WITH YOUR A.R.E. SERIAL NUMBER.
This is a molded palm handle lock assembly for the ARE Z-series fiberglass truck cap.  This replacement includes the handle/lock assembly, the rear plastic housing with the nuts necessary to secure it to the glass door, a new rubber gasket to seal to the glass, a new cable to run to each side latch and the crimps necessary to secure the new cable to the existing door latches.  The kit also includes two keys.  This handle assembly IS NOT the keyless entry compatible model.
PLEASE VIEW THE REAR PHOTO SHOWN ABOVE PRIOR TO ORDERING THIS PART.  THIS HANDLE HAS THREE STUDS THAT WILL NEED TO SLIDE THROUGH THE GLASS OF THE CAP, THEN THE WASHER AND NUT GET INSTALLED ON THE BACK SIDE.  A.R.E. HAS USED THIS ON THEIR Z-SERIES CAPS FOR APPROX. 10 YEARS.  IF YOU HAVE ANY DIFFERENT TYPE OF HANDLE ON YOUR A.R.E. Z-SERIES DO NOT PURCHASE THIS ONE.